Upload & Release A New Add-In - Fujitsu FI-6010N Operator's Manual

■ Upload & Release a New Add-in
Uploads a new Add-in module and issues an update call as needed.
The new Add-in update module will be released, and applied to the scanners when the one of the
following occurs:
Scanner is started, or resumed from the standby mode
Scanner is logged out
Scanner is notified of any update modules
Scanner has an automatic update scheduled
Updates can be applied to the scanners that are in power-off or standby mode using Wake-On-
LAN.
If the Add-in module is already available, the module is replaced. However, if the date of the last
modified Add-in module version is the same as, or earlier than the currently available one, the
module cannot be uploaded.
Upload an Add-in Module for the Add-in Group selected above.
Select the [Browse] button to specify the install module file.
Select the [Upload] button to upload the Add-in module.
Issue an Update Call
Check the checkbox to issue an update call.
When the checkbox is selected, even if a scanner is not started or logged in to, the update
module is sent and applied to the scanner according to the Scanner Notification Schedule.
However, if the update is released while logged in to a scanner, the update will be applied
after logged out. If any other available updates are pending, those are also applied at the
same time.
Scanner Notification Schedule
Sets the schedule to notify Add-in module.
Now
Issues a call immediately.
Later
Specifies the date and time to issue a call.
The default value is 00:00 of the following day. The value can be specified within the range
between the current time and a month later.
Update call schedule uses the Central Admin Server timezone.
ATTENTION
When issuing a call, set a time that does not conflict with that set for
"Software Update Time-Period Restrictions" on the "Central Admin
Server Settings" window.
fi-6010N Network Scanner Operator's Guide
5.10 Installing an Add-in
5
265