Table of Contents
Advertisement
HDT8012
6.3 Order of steps during commissioning
Removing the service slot cover
Loosen the screws on the service slot cover by using a Torx Tx10 screw driver and remove the service
slot cover.
Connecting the cables
Please connect all required cables. Always use the grommets to correctly install the cables.
ATTENTION
Breaching of IP protection
The device can be damaged if the service slot cover is not attached or is
attached incorrectly!
Make sure that the service slot cover is attached correctly before
starting operation!
Recommendation for use:
Before attaching the service slot cover, make sure that the seal is clean,
undamaged and dry.
6.4 Operation
The device should be operated by trained and instructed personnel only.
The manufacturer must be contacted if damage is found.
6.5 Decommissioning
The device can be shut down using the ON/OFF pushbutton, the ignition function and using the
software.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
24
Advertisement
Table of Contents
