Sony Digital 8- TRV240 Operating Instructions Manual page 36

Playing back a tape
To not display various settings
Set DATA CODE to DATE in the menu settings (p. 105).
The display changes as follows when you press DATA CODE on the Remote
Commander:
date/time +-+ no indicator
Notes on the data code function
l
The data code function works only for tapes recorded in the Digital8 E3 system.
l
Various settings of the recording data are not recorded when recording images on
"Memory Stick"s (except DCR-TRV240).
Recording data
Recording data is your camcorder's information when you have recorded. In the
recording mode, the recording data will not be displayed.
When you use data code function, bars (-- -- --) appear if:
- A blank portion of the tape is being played back.
- The tape is unreadable due to tape damage or noise.
- The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to the TV, the data code appears on the TV screen.
Remaining battery time indicator during playback
The indicator indicates the approximate continuous playback time. The indicator may
not be correct, depending on the conditions in which you are playing back. When you
close the LCD panel and open it again, it takes about one minute for the correct
remaining battery time to be displayed.
Various playback modes
_'
To operate video control buttons, set the POWER switch to VCR.
To playback pause (view a still image)
Press II during playback. To resume normal playback, press II or ).
To advance the tape
Press w in the stop mode. To resume normal playback, press F.
To rewind the tape
Press 44 in the stop mode. To resume normal playback, press F.
To change the playback direction
Press < on the Remote Commander during playback to reverse the playback direction.
To resume normal playback, press D+.
To locate a scene monitoring the picture (picture search)
Keep pressing 4 or m during playback. To resume normal playback, release the
button.
36