Venting Information - HearthStone Tribute DV 8050 Owner's Manual And Installation Manual

HearthStone Quality Home Heating Products, Inc.
V I
ENTING NFORMATION
V C
ENT ONNECTION
The Tribute DV Direct Vent is
1.
approved for installation only with
the vent connecting components
listed; Simpson Dura-Vent Direct
Vent GS, AmeriVent Direct, Selkirk
Direct Temp™
Secure Vent systems.
Install the vent system according to
2.
the manufacturer's instructions.
R P
ESTRICTION LATE
There is a vent restriction plate that adjusts
the flow rate of exhaust gases. This insures
proper flames and efficiency for the wide
variety of vent configurations. Controlling
the draft also changes the aesthetics of the
flame. The restriction plate consists of a
rotating shutter behind the starter section of
pipe and an adjustment plate with an index
hole used to hold the shutter in a fixed
position. The restriction plate has unlimited
or
EXCELDirect
10
settings. Depending
configuration, you may be required to adjust
the restriction plate position. For straight
out the back installations no adjustment
to the restrictor is necessary.
A
DJUSTMENT TO
P
LATE
Make sure the unit is cool before touching
any part of the firebox.
restrictor for maximum flame appearance,
loosen the Phillips head screw, found on the
upper rear right side of the stove. Spin the
indicator tab into the desired position.
Rotating counterclockwise
exhaust gasses, while rotating clockwise
opens the exhaust gases. Once the desired
restriction is reached,
screw.(Refer to figure 4)
unlimited positions for the restriction plate,
one (1) being the lowest and three (3) being
the highest. (Refer
Configuration – Figure 5 for recommended
restriction plate positions)
NOTE: These positions are based on lab
results and can have some variance.
Tribute DV Model #8050
on the vent
R
ESTRICTION
To adjust your
closes the
tighten the
There are
to Venting