2N VoiceBlue MAX User Manual page 65

AT%N#0=op/np,...op/np
AT%N#1=pr/n,...pr/n
AT%N#2..7=pr/n,...pr/n
AT%N#9=net,max
LCR Table
AT&R
AT%R##=net,hh:mm/hh:mm/w
,gr*
Test Calls
AT!SGxx=dial
AT!WGxx
AT!D
Trace
AT!RE
AT!Lx
AT!Rx
AT!RR
AT!RX
SMS Control
AT!G=#
AT^MS=ch
®
2N TELEKOMUNIKACE a.s., www.2n.cz
List of prefixes replaced by new prefixes
(#–number of netlist; op–old prefix;np–new
prefix)
List of prefixes dialled into ISDN (to be used for
LCR table) pr=prefix n=length of number
(parameter /n is optional)
Other 7 lists of prefixes dialled into ISDN
Net–network number, max–default length of
number dialled from ISDN
Shows LCR table
Settings of line ## (0..63) of LCR tablenet –
number of network list (0..8)hh:mm/hh:mm/w*
– line using time limitation gr – GSM group
numbers
Initiates testing call from AUX interface (xx is
the called interface):
00..31 GSM module
32– to GSM via GSM module according to call
prefix
Connects the following call from interface xx to
AUX interface
00..31 from GSM No.
32 first incoming calls from GSM
Terminates call on AUX interface
Trace can be activated for only one
session at a time
Start tracing of error messages on active
interface
Start tracing of LAN & Telnet on layer xx=2 –
Layers IP,TCP,Telnetx=3 – Layers TCP,
Telnetx=4 – Layer Telnet
Start tracing of ISDN PRI & GSM on layer xx=1 –
Layers 1,2,3,4x=2 – Layers 2,3,4x=3 – Layers
3,4x=4 – Layer 4
Start tracing (AT!R2) to COM1 interface
Stop tracing (AT!R2) to COM1 interface
SMS control can be activated for only
one session at a time
A6 – activate control via used session55 –
deactivate control via used session99 –
deactivate control on all sessions
Module status ch=0 – 31
65