2N VoiceBlue MAX User Manual page 54

CallBack function is enabled.
GSM number (CLIP) – user identification in a GSM/UMTS network.
AutoDial – enable/disable CLIP routing for the selected CLIP.
Dial to VoIP – enter the VoIP destination number for CLIP routing.
Auto CallBack – enable/disable CallBack for the selected CLIP.
Limit – set the maximum call length (in minutes).
Mobility Extension
The table registers the Mobility Extension users.
Name – enter the user name for calling to VoIP.
User – enter the registration user name for VoIP.
Password – enter the registration user password for VoIP.
GSM number (CLIP) – enter the user SIM card CLIP.
Follow me function – enable/disable call forwarding to a mobile user station
(based on CLIP).
SMS at no answer function – enable/disable sending of information SMS on
missed calls.
Ethernet configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in
IP address – the fixed IP address (v4) of the
interface.
Subnet mask – the subnet mask for the
Default gateway – The IP gateway IP address (v4) in the Ethernet network.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Note
Remember to activate the CallBack mode in the GSM incoming
groups window for a proper CallBack function.
Note
You are recommended to read the Mobility Extension section on
page carefully before using the Mobility Extension function.
Caution
Incorrect settings, e.g. enabling the
result in a denial of access to the
ation. To avoid this, restore the GSM gateway default settings.
Refer to Subs. 3.1
2N
®
2N VoiceBlue
DHCP client
®
2N VoiceBlue
for details.
®
2N VoiceBlue MAX
®
VoiceBlue MAX Ethernet
MAX Ethernet interface.
service, may
MAX configur
.
54