2N VoiceBlue MAX User Manual page 49

After call relax delay – interval between the current call termination and next call
setup via the same GSM/UMTS module. 2 seconds is recommended for
high–traffic installations.
Disconnect call
Specify the reasons for an immediate disconnection of an outgoing GSM/UMTS call.
Send CLIP from VoIP to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – the CDN / CLIP separating character.
Modify (" removes one digit) – you can change the CLIP. The "– character is used
for deleting one char from the left.
Basic settings
Roaming enabled for network code – set the international network identifier for
roaming purposes consisting of the following two codes:
Hence, the international identification code for T–Mobile CZ is 23001. Leave this field
empty to disable roaming.
String
<empty> Roaming is disabled
2300
23002
230XX
XX001
XXXXX
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Caution
The BTS lock service works with specific GSM modules only
(Q55)!
An error in BTS identification results in a GSM module login
failure.
Caution
The Send CLIP from VoIP to GSM
by the GSM/UMTS provider. If not, the provider's network may
reject the call!
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T–Mobile – 01, 0202, Vodafone –
03).
Roaming is disabled (5 digits is the minimum count)
Roaming is enabled for networks with MCC+MNC code 23002
Roaming is enabled for networks with MCC+MNC codes 23000 – 23099
Roaming is enabled for networks with MCC+MNC codes 00001 – 99001
Roaming is enabled for any network
Note
Check the GSM/UMTS searching priorities on the SIM card using
your mobile phone before enabling roaming.
service must be supported
Note
49