Basic Operation; I Setting A Frequency; I Setting A Squelch Level; I Anl Function - Icom IC-A24E Instruction Manual

3

BASIC OPERATION

I Setting a frequency

ï Using keypad
q Push [PWR] for 2 sec. to turn power ON, then push
[CLR• ] to select the frequency mode when memory CH
DEL
number appears on the function display.
w Push 5 appropriate digit keys to input the frequency.
• Push [1• ] as the 1st digit.
DVOR
• When a wrong digit is input, push [CLR•
then repeat step w again.
• Push [ENT] to enter consecutive zero digits.
• Only [2• ], [5•
TO
tered as the 5th and final digit.
[EXAMPLE]
• 111.225 MHz: Push
• 117.250 MHz: Push
• 120.000 MHz: Push
• 125.300 MHz: Push
ï Using the tuning dial
q Push [PWR] for 2 sec. to turn power ON, then push
[CLR• ] to select the frequency mode when memory CH
DEL
number appears on the function display.
w Rotate [DIAL] to set the desired frequency.
• To select the 1 MHz tuning step, push
[DIAL]. Push
8
DEL
], [7• ] and [0•
DUP-W BANK
again to return the normal tuning.

I Setting a squelch level

The transceiver has a noise squelch circuit to mute undesired
noise while receiving no signal.
q Push [SQL], then rotate [DIAL] to select the squelch level.
• 'SQL--0' is open squelch and 'SQL--24' is tight squelch.
• Appears "
w Push [SQL] or [CLR•
] to clear,

I ANL function

] can be en-
The ANL (Automatic Noise Limiter) function reduces noise
components such as that caused by engine ignition systems
while receiving.
• Push [ANL•
" " appears on the display while the ANL function is ON.
, then rotate
" while the squelch is open.
] to exit the squelch set mode.
DEL
] to turn the ANL function ON/OFF.
SCAN