Scan Operation; I Scan Types; I Com Band Scan; I Memory Scan - Icom IC-A24E Instruction Manual

5

SCAN OPERATION

I Scan types

The transceiver has 2 scan types to suit your needs.
COM BAND SCAN
108.00 118.00
MHz MHz
MEMORY SCAN
non-TAG channel
Mch 2 Mch 4
Mch 1
Mch 19 Mch 10
16
Repeatedly scans
136.975
all frequencies
MHz
over the entire
COM band.
Scan
Jump
Repeatedly scans se-
lected memory BANK's
all "TAG" memory chan-
Mch 6
nels. Used for checking
Mch 7
often-used channels and
non-TAG
bypassing usually busy
channel
Mch 8
channels such as con-
trol-tower frequencies.

I COM band scan

q Push [CLR•DEL] to select the frequency mode.
w Push [SQL], then rotate [DIAL] to set the squelch level to
the point where noise is just muted.
e Push
, then push [ANL•
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•

I Memory scan

q Push [MR•
] to select memory mode.
MW
• Push , then push [0•
BANK
sired. Push [CLR• ] to exit the BANK selection mode.
DEL
w Push [SQL], then rotate [DIAL] to set the squelch level to
the point where noise is just muted.
e Push
, then push [ANL•
• When a signal is received, the scan pauses until it disappears.
• To change the scanning direction, rotate [DIAL].
r To stop the scan, push [CLR•
NOTE: Program 2 or more memory channels to start
memory scan.
] to start the scan.
SCAN
].
DEL
] to select the BANK number if de-
] to start the scan.
SCAN
].
DEL