Triumph Adler P-C2160DN Operation Manual page 93

>Arlen
?Report
>Report
Copies
>Report
Copies
>Report
Delete
>Private/Stored
?Harold
5
Press [OK]. The job name entered in the printer driver (Report, in
this example) appear with a blinking question mark (?) before the
letters.
6
Press  or  to scroll to the desired job title.
Note If you selected All Files, this process is applied to
all the documents in the Quick Copy/Proof-and-Hold.
7
Press [OK]. The number of copies to be printed can be set. To
increase the copy count, press  to decrease the copy count, press
001 .
Note If you selected All Files, press  after Copies --
- is displayed to set the number of copies. When using the
number of copies specified with print job, select Copies ---.
8
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Proof-and-Hold Job
1
Follow steps 1 through 6 in the above section to let the title of the job
to be deleted displayed.
2
When the title of the job to be deleted is displayed, e.g. Report,
press [OK]. The cursor (_) below the copy count starts to blink.
001
3
Press  repeatedly until Delete appears below the title.
4
Press [OK]. The message Processing appears and the stored job
is deleted.
Private/Stored (Printing a private print/stored job)
In private printing, you can specify that a job is not printed until you
release the job from the operation panel. When sending the job from the
application software, specify a 4-digit access code in the printer driver.
The job is released for printing by entering the access code on the
operation panel ensuring confidentiality of the print job.
In the stored job mode, access codes are not mandatory, but can be set
on the printer driver if printing with PIN security is required. Then, the
access code must be entered on the operation panel to print a stored job.
Print data will be stored in the SSD after printing.
Refer to Printing System Driver User Guide for the driver settings.
Releasing a Private/Stored Job
1
Press  while Job Box > is displayed.
2
Press  or  repeatedly until >Private/Stored appears. The
name entered in the printer driver (Harold, in this example) also
appears.
3
Press [OK]. A blinking question mark (?) appears before the user
name.
4-25
Using the Operation Panel