Triumph Adler P-C2160DN Operation Manual page 120

>>DHCPv6
? Off
>>NetBEUI
? On
>>SNMPv3
? Off
1
Press  while >TCP/IP (IPv6)
2
Press  or  repeatedly until >>DHCPv6 appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using  or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Protocol Detail (Detailed settings for the network protocol)
This selects the settings for Protocol Detail.
The options available in the Protocol Detail settings are as follows:
• NetBEUI (NetBEUI setting)
• SNMPv3 (SNMPv3 setting)
• FTP (Server) (FTP (Server) setting)
• SNMP (SNMP setting)
• SMTP (SMTP setting)
• POP3 (POP3 setting)
• RAW Port (RAW Port setting)
• LPD (LPD setting)
• HTTP (HTTP setting)
1
Press  while Network > is displayed.
2
Press  or  repeatedly until >Protocol Detail > appears.
NetBEUI (NetBEUI setting)
Selects whether or not to receive documents using NetBEUI.
1
Press  while >Protocol Detail > is displayed.
2
Press  or  repeatedly until >>NetBEUI appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using  or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
SNMPv3 (SNMPv3 setting)
Set SNMPv3.
1
Press  while >Protocol Detail > is displayed.
2
Press  or  repeatedly until >>SNMPv3 appears.
3
Press [OK]. A blinking question mark (?) appears.
4-52
Using the Operation Panel
On > is displayed.