>>Maintenance ?
>>DEV-CLN ?
>>LSU ?
Maintenance (New Maintenance Kit replacement confirmation
setting)
This specifies the setting for confirmation of replacement with the new
Maintenance Kit (resets the total number of Maintenance Kit print
images). This is primarily used for maintenance by service personnel. (P-
C2660DN only)
Note The Maintenance menu is displayed only when Replace
MK appears.
1
Press while >Service > is displayed.
2
Press or repeatedly until >>Maintenance appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. The confirmation of replacement with the new
Maintenance Kit is set.
5
When the replacement ends, the display returns to Ready.
DEV-CLN (Developer/Refresh mode setting)
This sets the refresh mode for the developer. When the printing quality
declines, refreshing the developer can restore the printing quality. This is
primarily used for maintenance by service personnel.
1
Press while >Service > is displayed.
2
Press or repeatedly until >>DEV-CLN appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. Developer refreshing begins and Please wait is
displayed.
5
When refreshing ends, the display returns to Ready.
LSU (LSU cleaning mode setting)
This sets the cleaning mode for the LSU. When the printing quality
declines, cleaning the LSU can restore the printing quality. This is
primarily used for maintenance by service personnel.
1
Press while >Service > is displayed.
2
Press or repeatedly until >>LSU appears.
3
Press [OK]. A question mark (?) appears.
4
Press [OK] again. LSU cleaning mode begins and Please wait
(Cleaning) is displayed.
5
When cleaning ends, the display returns to Ready.
4-106
Using the Operation Panel