Triumph Adler P-C2160DN Operation Manual page 143

ID
_
Password
_
ID (Administrator ID input)
To use the Sleep Level settings, you must enter an administrator ID. For
information on how to set the administrator ID, refer to Administrator
(Administrator settings) on page 4-94.
1
Press  while >Sleep Level Set. > is displayed.
2
The message display shows ID and a blinking cursor (_).
3
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use  and  to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
4
Press [OK]. Proceed to the next step Password (Administrator
Password input).
Password (Administrator Password input)
To set up the Sleep Level settings, you must enter an administrator ID and
administrator password. For information on how to set the administrator
password, refer to Administrator (Administrator settings) on page 4-94.
1
Once you have entered the correct ID in the previous step (ID
(Administrator ID input)), the message display shows Password
(Administrator password input) and a blinking cursor (_).
2
Press  or  to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified password. Use  and  to move
the cursor right and left. Enter a password consisting of between 0 (no
settings) and 16 numbers.
Note If you enter the incorrect administrator ID or password,
the message Wrong ID or Wrong Password appears and
the input screen then reappears. Re-enter the ID or password
correctly.
3
Press [OK]. The Sleep Level settings screen appears.
Sleep Level (Sleep level setting)
There are two sleep modes with different levels of sleep: Quick Recovery
and Energy Saver.
Quick Recovery Mode: The recovery from the sleep mode is faster than
when using Energy Saver mode.
Energy Saver Mode: This makes it possible to reduce energy
consumption even further than with Quick Recovery mode. With Energy
Saver mode, you can set whether to enable the Energy Saver mode for
each separate function.
Note For information on the Quick Recovery mode and Energy
Saver mode, refer to Energy Saver Function on page 2-25.
Sleep Level Set. menu is not displayed when the optional network
interface kit (IB-50) or wireless network interface kit (IB-51) has
been installed.
1
After entering the administrator ID and password, press  or 
repeatedly until >>Sleep Level appears.
4-75
Using the Operation Panel