Triumph Adler P-C2160DN Operation Manual page 35

Setting
SMTP
SMTP Protocol
SMTP Server
Name
SMTP Port
Number
SMTP Server
Timeout
Authentication
Protocol
SMTP Security
POP before
SMTP Timeout
Connection Test
Domain
Restriction
POP3
POP3 Protocol
Check Interval
Run once now
Domain
Restriction
POP3 User
Settings
3
Enter the appropriate values to each field.
Description
Set to send e-mail from the machine.
Set SMTP protocol. Set the SMTP (E-mail TX) setting to On on
the Protocol Settings page.
Enter the host name or IP address of the SMTP server.
Specify the port number to be used for SMTP. Use the SMTP
default port 25.
Set the amount of time to wait before time-out in seconds.
Set whether SMTP authentication is used. To use
authentication, enter the user information for authentication.
Set SMTP security.
Turn on SMTP Security in SMTP (E-mail TX) on the
Protocol Settings page.
Specify the time in seconds until the connection to the POP
server times outs. This can be set when POP before SMTP is
selected in Authentication Protocol.
Tests to confirm that the settings are correct.
Set whether or not domains are restricted. Click the Domain
List and enter the domain names of addresses to be allowed or
rejected. Restriction can also be specified by e-mail address.
Set to receive e-mail at the machine.
Set POP3 protocol. Set the POP3 (E-mail RX) setting to On on
the Protocol Settings page.
Specify the interval for checking for incoming e-mail in minutes.
Click Receive to connect to the POP3 server immediately and
check for incoming E-mails.
Set whether or not domains are restricted. Click the Domain
List and enter the domain names of addresses to be allowed or
rejected. Restriction can also be specified by e-mail address.
Configure the settings for POP3 user accounts and the POP3
server. You can configure up to three users.
2-9
Printing Operation