Wiring; Power - Hengstler eXtendo X-56 Operating Manual

®
eXtendo Thermal Printer Family
3. Slide the paper guide all the way to the outer edge of the slotted area. Press on first one,
then the other of the arms to snap these two tabs into place.
4. The paper guide is now installed. Push or pull on the end of the paper guide to position it
where desired. (See figure 11.) You will hear the paper guide click as it locks into each
position.

6.4. Wiring

6.4.1. Power

Power is connected to the eXtendo
connector consists of a JST VHR-2N (RA 3.96) shell and two SVH-21T-P1.1
contacts. Wiring is as follows:
Pin
1
2
The upper contact on the connector is common; the lower contact is the positive (+)
voltage. See the "Sleep Mode" section for connection of power when equipped with
the Sleep Mode option.
Part No. D 684 124
Function
24 VDC (-)
24 VDC (+)
Mod. No. 4 080812 LEV
HENGSTLER
Figure 10
Figure 11
®
thermal printer via a JST connector. The
page 24 of 38