Specifications - Hengstler eXtendo X-56 Operating Manual

®
eXtendo Thermal Printer Family
13.2. X-80 Specifications
Technology:
Print Speed:
Duty Cycle:
Resolution:
Minimum Print Length:
Printhead Life
Abrasion (based
on 12.5% print density)
Electrical:
Graphic Driver:
Bar Codes:
Internally Generated:
Externally Generated:
Paper Width:
Printable Width:
Paper Weight:
Paper Capacity:
Interface Types:
Operating Voltage:
Current Draw:
In standby, approx.
Sleep mode (optional)
While printing
24 VDC
Part No. D 684 124
Direct Thermal
24 VDC: 13.7 ips (350 mm/sec) max.
12 VDC: 5.1 ips (130 mm/sec) max.
10-36 VDC: 5.1 ips (130 mm/sec) max.
24 VDC: Thirty (30) 150 mm long printouts per minute max.
12 VDC: Fifteen (15) 150 mm long printouts per minute max.
10-36 VDC: For each printout up to 210 mm long and with a
print density of 25% or less, a 9 second pause after each
printout. Consult factory regarding duty cycle for print
densities over 25%.
203 dpi (8 dots/mm)
15 mm (Note; At a length of 15 mm, the paper will not be
visible at the end of the paper chute. Print at least 40 mm
in order for the paper to be visible. The 15 mm minimum
length is included to allow for applications where the
printer is ordered without the chute and where very short
printouts may be dropped into a chute or similar
conveyance.)
100 km of paper
100 million dot pulses
®
Windows 2000/XP, Linux
UPC-A, UPC-E, EAN-13, EAN-8, Code 39,
Interleaved 2 of 5, Code 128, Codabar, PDF 417
Any, generated by Windows
2.36 to 3.38 inches (60-86 mm)
3.15 inches (80 mm)
50 to 250 g/m²
(cutter dependent)
6 inch (150 mm) roll diameter
12 inch (300 mm)
(reduced performance)
a) USB 1.1 industrial
Interface cable length 3 meters max.
Transmission rate: 1.5 Mbit/sec and 12 Mbit/sec
b) RS-232
Interface cable length 3 meters max.
9,600 to 115,200 baud
24 VDC± 10%
12 VDC (11-15 VDC) (optional)
10-36 VDC (optional)
150 mA
<50 µA
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 24.0 VDC, and print
density (coverage) of 12.5%: 1.4 A avg.
With Hengstler paper, at 21° C ambient temperature, with a
print speed of 100 mm/sec, voltage of 24.0 VDC, and print
density (coverage) of 25%: 2.3 A avg.
Mod. No. 4 080812 LEV
HENGSTLER
®
standard GDI file by host
page 36 of 38