Document History - Hengstler eXtendo X-56 Operating Manual

®
eXtendo Thermal Printer Family
Revision Date
1.00 2008 Jan 28
1.01 2008 Mar 31
1.02 2008 June 27
1.03 2009 Jan 25
1.04 2009 Feb 20
1.05 2009 May 15
1.06 2010 July 19
1.07 2011 April 21
Part No. D 684 124

Document History

Init Status Description
CBL Closed Initial version
CBL Closed Removed excessive warranty value entries under
"Features Selected at Time of Order". Corrected
figure ref. no. under Wiring, Interfacing. Removed
"Heading" format for word "Serial" under Wiring,
Interfacing.
CBL Closed Add note re 15 mm minimum paper length.
Removed Basic Firmware option and 130 mm/sec
option. Add print speed of 130 mm/sec max. for
12/10-36 VDC models. Change 10-39 VDC to 10-36
VDC. Change Printhead Position description to
describe three positions. Troubleshooting section
expanded. Black Mark text clarified. Cutter
Operation text clarified. Change sleep mode current
spec to 50µA.
CBL Closed Corrected formatting of columns in serial and USB
cable pinout tables. Company logo changed from
graphics to text. Add duty-cycle specification. Add
photo of USB and Multivoltage version for connector
positioning. Add description of connectors on gear
side. Modify paper roll holder text. Modify text to
match new photos. Add note re specifications under
Power Supply section. Update paper roll holders in
option chart. Added paper roll holder drawing
reference. Add schematic fragment for PVE/Aux.
sensor connection. Add registered trademark
symbol (®) to "eXtendo".
CBL Closed Revise printhead position to two positions (three
positions used in prototypes only). Add "printhead
up" status to LED Indicators. Revise Head Status
Sensor to reflect no printing when printhead is up.
Troubleshooting section revised re printhead up
operation. Added printing current specs under
Technical Specifications.
CBL Closed Add section on low current operation. Add FCC
Part 15 statement. Add EN55022, EN55024
statements. Add two "General Information" points.
Add "Function" section. Add cable length limitation
to interface specs. Add warning with photo about
damaging cutter bracket when improperly mounted.
Remove "Available soon" from Linux driver
reference in intro. Add fanfold paper reference in
"Paper" section. Add explanation for moving cutter
blades manually.
CBL Closed Add note about no serial handshaking with sleep
mode. Add explanation of chute sensor/partial-cut.
Add mounting hole diagram and expand mounting
comments. Update cover photo. Add installation of
paper guide.
CBL Closed Changed P/N of paper spec document. Correct
voltage in print speed specifications. Increase 24
VDC print speed to 350 mm/sec.
Mod. No. 4 080812 LEV
HENGSTLER
page 3 of 38