Features Selected At Time Of Order - Hengstler eXtendo X-56 Operating Manual

®
eXtendo Thermal Printer Family
Additionally, the optional chute/jam sensor is monitored while first printing after a cut.
After a cut, the printer "knows" where the end of the paper is. As printing takes place,
the printer also "knows" how many paper advance steps have been made, and
approximately when the end of the paper should reach the chute/jam sensor. If the
paper does not reach the sensor when expected, the printer assumes that a paper
jam has taken place and signals this fact via the Status command.
Note: Care must be taken when mounting the eXtendo printers to insure that the
sensor is not exposed to direct sunlight. The multiple wavelengths of sunlight can
cause false readings from this sensor. Therefore, always shield the chute and sensor
from direct sunlight by the use of chutes, shrouds, covers and similar techniques.

3.7. Features Selected at Time of Order

One of the strengths of the eXtendo
select precisely the features needed, rather than settling for performance less than desired or
having to pay for features that will never be used. The current set of available options is listed
below.
Feature Description
Basic Unit
Communications
Interface
Cutter
Print Speed
Chute/Jam Sensor
Environmental
Range
Software
Configuration
Voltage
Sleep Mode
Presenter
(available Q3 2008)
Paper Roll Holder
Paper Chute
Paper Pre-End
Sensor
Paper Guides
Note: Standard on X-80
Extended Warranty
Due to the wide variety of options possible, it is necessary to be able to identify what features
are included in each printer. Some features, such as the cutter or PPE sensor, are visually
obvious. Other features, such as the print speed, software configuration and extended
warranty, are not. Therefore, this data is stored as a code in each printer when it is
Part No. D 684 124
®
family of thermal printers is that it allows the designer to
Option 1
X-56 X-80
USB Serial (RS-232)
Twincut, Full and
Twincut, Full Cut
Partial Cut, up to 120
Only, up to 160 g/m²
g/m²
350 mm/sec max.
Not included Included
0 to +50ºC
-25 to +70ºC
25% to 80% RH,
20% to 100% RH
non-condensing
Advanced
24 VDC 12 VDC
Not included Included
Not included Included
100 mm roll mounted
on data connector
side
150 mm roll mounted
Not included on data connector
side
300 mm roll mounted
on data connector
side
Not included Included
Not included Included
Not included Included
Not included 3 year warranty total
Mod. No. 4 080812 LEV
HENGSTLER
Option 2
Rotary, Full Cut
Only, up to 250 g/m²
10-36 VDC
100 mm roll mounted
on gear side
150 mm roll mounted
on gear side
300 mm roll mounted
on gear side
(avail. Q3/2009)
(avail. Q3/2009)
Option 3
page 18 of 38