Mounting The Printer; Paper Guides; Wiring; Power - Hengstler TS-56 Operating Manual

TwinSide TS™ Thermal Printer Family

5.2. Mounting the Printer

The TwinSide TS™ printer is built with four M4 threaded mounting holes for mounting from
below, and four M4 threaded mounting holes for mounting from the side. These holes are
machined into threaded inserts, and the inserts pressed into reinforced openings which are
part of the plastic frame.
NOTE: Maximum penetration of the mounting screws into these inserts is 8 mm. Penetration
by more than 8 mm can interfere with printer operation and may damage the printer.
The hole layouts (viewed from above the printer) for mounting the TS-56 with screws from
underneath are shown below. Please refer to the drawings specified in section 1.1 for more
detailed dimensions and mounting hole locations for mounting from the side.
Figure 8a – TS-56 bottom

5.3. Paper Guides

P/N 0691001 is a 54 mm wide model of the TS-56 and does not come with separate paepr
guides. Instead, these guides are molded into the housing. No adjustment is necessary or
possible.

5.4. Wiring

5.4.1. Power

Power is connected to the TwinSide TS™ thermal printer via a JST connector. The
connector consists of a JST VHR-4N shell and two SVH-21T-P1.1 contacts. Wiring is
as follows:
Pin Function
1 Ground (0 VDC)
2 Ground (0 VDC)
3 24 VDC (+)
4 24 VDC (+)
Part No. D 691 023A
Figure 8b – TS-56 side
Mod. No. 4 120912 LEV
HENGSTLER
page 21 of 34
®