Wiring; Power; Data Interfacing Usb; Data Interfacing Rs232 - Hengstler eXtendo XF 4 120322 Eli Operating Manual

Table of Contents

Advertisement

XF
eXtendo®
Thermal Printer Family

4.5 Wiring

4.5.1 Power

Power is connected to the eXtendo® XF thermal printer via a JST connector. The connector
consists of a JST VHR-2N (RA 3. 96) shell and two SVH-21T-P1. 1 contacts. Wiring is as
follows:
Pin
1
2
The left contact on the connector is common; the right contact is the positive (+) voltage
(→ Fig. 3).
Note: USB Signal GND and power GND are connected to each other.

4.5.2 Data Interfacing USB

T eXtendo® XF printer employ USB2.0 connection a standard digital camera USB interface
cable (5 pin Mini-B connector on the printer end) to communicate with the host. Be sure
that the Mini-B connector is fully engaged with the mating connector on the printer. The
other end of the cable plugs into a USB port on the host.
USB Pinout
Number
Please note that the shell of the USB connector only makes a capacitive connection to the
signal ground.
Please observe the notes regarding signal grounding in → Chapter 2.2.

4.5.3 Data Interfacing RS232

The printer is shipped with the following serial settings as default: 115,200 baud, 8 data
bits, one stop bit, no parity, hardware flow control, and host transmission not blocked (this
last feature is intended for use with lower sophistication hosts that cannot read the
eXtendo® XF printer's status data. It uses the hardware handshake lines to prevent the host
from sending more data if the printer registers "paper out").
The eXtendo® XF printer uses a JST ZHR-6 connector shell with JST SZH-002T-P0.5 contacts
to make the RS-232 connection. Hengstler can provide a serial cable for direct connection
to PCs with a DB-9 connector on one end (→ section 12 Spare Parts and Accessories).
Connections are as follows, should you decide to make your own data cable or connectors.
Part No. D-684-399
Function
0 VDC/GND (-)
(blue
24 VDC
(+)
(red
wire)
Pin
Signal name I/O Function
1
NC
2
D- I/O
3
D+ I/O
4
NC
5
SGND
Mod. No. 4 120322 Eli
wire)
no connection
Data -
Data +
no connection
I/O Signal GND (internally connected to 0 VDC)
page 19 of 35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Extendo x-56 xf

Table of Contents