Controls - Singer VC1120 Instruction Manual

2. Telescopic tube
For installing a telescopic tube, connect the telescopic tube part to the hand grip of the fl exible hose.
Then, extend the telescopic tube by pushing forward on the plastic button and by pulling the inner
stainless steel telescopic tube outward.
Adjust the telescopic tube to the length of you fi nd most comfortable during vacuuming.
3. Floor Brush
To connect the tube and fl oor brush, you push them together until they fi t. You can use the fl oor brush
on the carpet or on hard fl oors.

Controls

Note: Once the vacuum is fully assembled, unwind a suffi cient length of cable and insert the
plug into the electrical outlet. A yellow mark on the power cord shows the ideal cable length. Do
not pull the power cord beyond this mark.
1. Insert the power plug into the electrical outlet.
2. Press the on/off switch in order to start or stop the vacuum cleaner.
3. To rewind the power cord, press the cord rewind button with one hand and guide the power cord
with the other hand to ensure that it does not whip causing damage or injury.
4. You can adjust the suction power with the speed control button on the vacuum cleaner. Suction
can also be controlled using the airfl ow regulator on the handle: closed for maximum suction,
open for reduced suction.
Replacing the dust bag
When the indicator shows red, then it is the time to change the dust bag. Always unplug the ap-
pliance before you replace a dust bag or fi lter.
1. Remove the fl exible hose.
2. Open the dust container cover by pushing the dust container cover release button.
3. Remove the dust bag from the holder
4. When inserting the new dust bag into the holder make sure to slide it in completely.
5. Close the dust container cover
WARNING: If the dust bag is not fi xed to its proper position, the dust container cover cannot
be locked.
On/off button
Rewind button
Speed control button
8
ENGLISH