Ricoh D017 Service Manual page 997

No Function
Compression modes available in transmit
mode
5
0: MH only
1: Disabled
ECM during transmission
Bit 7 Bit 6
0 0
6
0 1
7
1 0
1 1
Switch 04 - Not used (do not change the settings)
Switch 05 - Not used (do not change the settings)
Switch 06 - Not used (do not change the settings)
Switch 07 - Not used (do not change the settings)
Switch 08 - Not used (do not change the settings)
Switch 09 - Not used (do not change the settings)
SM
Dedicated Transmission Parameters
Switch 03
This bit determines the capabilities
that are informed to the other
terminal during transmission.
If the setting is "Disabled", the bit
switch setting is used.
For example, if ECM is switched on
Setting
but is not wanted when sending to a
particular terminal, use the (0, 0)
Off
setting.
On Note that V.8/V.34 protocol and JBIG
compression are automatically
Not used
disabled if ECM is disabled.
If the setting is "Disabled", the bit
Disabled
switch setting is used.
179
Comments
D361/D510