Ricoh D017 Service Manual page 1240

Printer and P/S Options
4. Put the option SD Card (Printer Enhance Option or Scanner Enhance Option) in the
lower slot.
5. Turn the copier on.
6. Go into the SP mode and select SP5873-1.
7. Touch "Execute".
8. Obey the instructions on the display and touch "Execute" to start.
9. When the display tells you copying is completed, touch "Exit", then turn the machine
off.
10. Remove the option SD card from the lower slot.
11. Turn the copier on.
12. Go into the User Tools mode and confirm that update was successful.
User Tools> System Settings> Administrator Tools> Firmware Version> Next
13. Turn the copier off and reattach the SD card slot cover.
14. Return the copied SD card to the customer for safekeeping, or tape it to the faceplate
of the controller.
To undo an option update
1. Turn the main switch off.
2. Confirm that the RPCS Unit or Printer Unit SD card is in SD card the upper slot
3. Put the empty SD card (Printer Enhance Option or Scanner Enhance Option D383) in
the lower slot.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-2 (Undo Exec).
6. Obey messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the restored SD card from the lower slot..
9. Turn the main switch on.
10. Go into the User Tools mode and confirm that undo was successful.
User Tools> System Settings> Administrator Tools> Firmware Version> Next
11. Turn the copier off again, then reattach the cover.
Important Notes About SD Cards
Here are some basic rules about moving an application to another SD card.
The authentication data is moved with the application program to the target SD card.
Once an application has been moved from the original SD card, the original SD card
cannot be used unless the application is restored to the SD card with SP5873-2 (Undo
Execute).
SD cards must be stored in a safe location at the customer site The empty SD card
D383 12 SM