Ricoh D017 Service Manual page 996

Dedicated Transmission Parameters
No
Inch-mm conversion before tx
Bit 1 Bit 0
0 0
0-1
0 1
1 0
1 1
DIS/NSF detection method
Bit 3 Bit 2
0 0
2-3 0 1
1 0
1 1
V.8 protocol
4 0: Off
1: Disabled
D361/D510
Switch 03
Function
Setting
Inch-mm conversion
available
Inch only
Not used
Disabled
Setting
First DIS or NSF
Second DIS or NSF
Not used
Disabled
178
Comments
The machine uses inch-based
resolutions for scanning. If "inch
only" is selected, the printed copy
may be slightly distorted at the other
end if that machine uses mm-based
resolutions.
If the setting is "Disabled", the bit
switch setting is used.
(0, 1): Use this setting if echoes on
the line are interfering with the set-up
protocol at the start of transmission.
The machine will then wait for the
second DIS or NSF before sending
DCS or NSS.
If the setting is "Disabled", the bit
switch setting is used.
If transmissions to a specific
destination always end at a lower
modem rate (14,400 bps or lower),
disable V.8 protocol so as not to use
V.34 protocol.
0: V.34 communication will not be
possible.
If the setting is "Disabled", the bit
switch setting is used.
SM