Installing Controller Options
1.3 INSTALLING CONTROLLER OPTIONS
1.3.1 IEEE 1284 INTERFACE BOARD (B679)
Accessories
Check the accessories and their quantities against the following list:
No
1
IEEE 1284 Interface Board B679
Installation
Turn off the main power switch and disconnect the power supply cord.
1.
Remove the application cover (
2.
Remove the cover [A] of the board slot (
3.
Install the interface board [B] (
Use a screwdriver to tighten the knob-screws. Do not tighten manually,
because this can disconnect the board.
4.
Reattach the application cover (
If the 500-Sheet Finisher is installed, remove it before you attach the parallel
cable. Install the finisher again after you connect the parallel cable.
D383
Description
x1).
x2 knob screws).
x1).
Quantity
1
x1).
14
SM