Ricoh D017 Service Manual page 1239

5th Scanner
18. Connect the machine power cord and turn the main power switch on.
19. Enable the NIB and/or USB function.
To enable the NIB function, enter the SP mode and set SP5985-001 (On Board
NIC) to "1" (Enable).
To enable the USB function, enter the SP mode and set SP5985-002 (On Board
USB) to "1" (Enable).
20. If there was no HDD in the machine before you installed the Printer Enhance Option,
Printer Unit, or Printer/Scanner Unit:
Do SP5846 41 so the user can use the address book.
Do SP5853 to copy the preset stamp data to the hard disk. Then turn the main
power switch off/on
These SPs must be done immediately after installation of an HDD unit in a
machine that previously had no HDD.
The first time the machine power is turned on with the new HDD installed, the
system automatically takes the address book from the NVRAM and writes it on the
new HDD. However, only the system administrator can use the new address book
on the HDD at this time.
If you do SP5846 41 immediately after power on, then all users can use the
address book.
It is not necessary to format the new hard disk after installation.
1.2.4 PRINTER, SCANNER ENHANCE OPTIONS
Accessory Check
Refer to the "Common Accessory Table"
Installation
The installation of the printer enhance option and scanner enhance option is done with
SP5873 001 (Application Move).
If you are going to update the RPCS unit with both the printer and scanner
enhance options, the order of execution is not important.
1. Turn off the copier.
2. Remove the cover (
3. Confirm that the RPCS Unit or Printer Unit SD card is in the upper slot.
SM
x1).
11
Printer and P/S Options
D383