Table of Contents
Advertisement
"Calories" window: Shows calories burnt. When your hand is on the pulse sensors, it will show the
6.
current pulse data. When showing calories, the window will count from 0 to 999 calories. Upon reaching
999, the window will restart from 0. During countdown, the window will count down from the preset
amount to 0. Upon reaching 0, the machine will stop smoothly and show 'End'. It will then enter startup
mode after 5 seconds.
Centre LCD display window: In setting state, it will show P1-P24, U1-U3, HP1-HP2, FAT. When the
7.
machine is operating, the window will display a 400 meter running track. It will also show the lap
progress and number of laps. Upon completed of a lap, the display will "beep".
BUTTON FUNCTION:
"Program" button: During startup mode, press this button to choose a program. Programs are 'P1-P24,
1.
U1-U3, FAT" Manual mode is the default program. The default speed is 0.5 KM/H. ("0:00" is manual
program, P1-P24 is inner install program, U1-U3 is self-define program, FAT is the body fat test
function)
"HRC" button: During startup mode, press this button to choose heart rate control from HP1 to HP2.
2.
"MODE" button: During startup mode, press this button to choose between "0:00", "15:00", " 1.0 ", "50"
3.
( "0:00" is manual mode, "15:00" is time countdown mode, " 1.0 " is distance countdown mode, "50" is
calories counting down mode). When setting each mode, you can press speed +/- and incline +/- to set
the data, press "START" to start the machine.
"START" button: When the machine is connected to power and safety key attached, press this button at
4.
any time to start the machine. If starting from manual mode, the machine will operate at the lowest
speed: 0.5 km/h, incline 0.
"STOP/PAUSE" button: Press this button to stop the motor running.
5.
Pressing the STOP button once during your workout will pause the workout and the workout data on the
LCD will remain. Press the START button to resume your workout. Instead of pressing START, you may
clear the workout data by pressing the STOP button a second time.
"SPEED +", "SPEED –" buttons: During startup mode, set speed data with this button. When the
6.
machine is running, press theses buttons to adjust speed. Speed will be adjusted at 0.1 KM at each
press, when holding the button for over 0.5 seconds, the speed will change up or down continuously.
12
PRIME
Advertisement
Table of Contents
