FRONT HEADLIGHT ADJUSTMENT
- - Figs. 81 and 82
Adjust the headlights as follows:
--
Unload the tractor and inflate the tyres to the
specified pressure on level ground in front of -- if
possible -- a shaded white wall.
--
Mark two crosses on the wall corresponding to
the middle of the headlamps.
--
Reverse the tractor about 5 m. and switch on the
main beam headlights.
--
Points P - - P should be 5 cm below the crosses.
--
— To adjust the light beams, turn the screws (1)
to deflect the beams horizontally or vertically.
Replace bulbs which have blown by bulbs of the
same power (55/60 W).
SECTION 4 - - LUBRICATION AND MAINTENANCE
1
TRE0051A
NOTE: Under the EC regulations, the maximum
permissible overall width for tractors equipped with
standard tail--lights is 2150 mm. With wheels set at
maximum track width, the maximum overall width
obtainable is 2315 mm for machines with ROPS, and
2510 mm for machines with cab. If these wider
settings are adopted, the tail--lights must be mounted
to special extendible arms (available on request) so
that they can be adjusted to indicate the overall width
of the tractor.
81
1
1
82
4--37