Table of Contents
Advertisement
OPERATION 49
INJECTORS - - Fig. 58
Have your dealer check the pressure settings (see
page 8--6). To remove the injectors from the engine,
detach the lines and remove the connectors.
NOTE: Before loosening or disconnecting any part
of the injection system, thoroughly clean the area in
which you are going to work.
NOTE: Cover all injector lines and apertures to
prevent any dirt ingress.
OPERATION 50
FRONT AXLE HOUSING - - 4WD - - Fig. 59
Place a container under the axle housing, unscrew
plug (1), let all the oil drain out. Refill with new oil
through the filler/level plug hole (1) fig 44.
NOTE: For oil grades, see the lubrication charts
beginning on pages 4- -41.
OPERATION 51
DRAINING THE OIL FROM THE FRONT
AXLE FINAL DRIVES - - 4WD - - Fig. 60
Position plug (1) to its lowest point, place a container
under the plug hole and drain the oil.
Rotate the wheel so that the plug hole is in a
horizontal position and fill with new oil.
NOTE: For oil grades, see the lubrication charts
beginning on pages 4- -41.
SECTION 4 - - LUBRICATION AND MAINTENANCE
EVERY 1200 HOURS OR EVERY 2 YEARS
TRE0844A
58
59
60
4--27
Advertisement
Table of Contents
