Table of Contents
Advertisement
OPERATION 47
DRAINING THE HYDROSTATIC STEERING
OIL - - Fig. 56
Place a container under the reservoir, remove tube
(1) and drain the oil.
Refit the tube and clean the internal filter before filling
with new oil.
NOTE: For oil grades, see the lubrication charts
beginning on pages 4- -41.
OPERATION 48
DRIVE SHAFT SLEEVE FOR 4WD FRONT
AXLE CONNECTION - - Fig. 57
Check as follows:
--
Disassemble the front axle drive shaft guard;
--
Loosen screws (1), to disconnect the support (2)
from the drive housing;
--
Remove circlip (4);
--
Move the sleeve (3) as shown by the arrow, lower
the drive shaft until the sleeve can be removed
and check that the inner groove does not show
signs of excessive wear.
WARNING
If the sleeve inner groove should prove excessively
worn, refer to your dealer for a possible replacement.
4--26
SECTION 4 - - LUBRICATION AND MAINTENANCE
23762
4
3
26245
1
56
1
57
Advertisement
Table of Contents
