Table of Contents
Advertisement
--
If adjustment is required, fully release the
handbrake (lever down). Slacken the lock nuts
(1) and turn the hexagon sleeves (2) until brake
pedal free travel is 5 mm. Finally, tighten the lock
nuts (1).
OPERATION 3
FAN BELT (ALL VERSIONS WITHOUT
AIR- -CONDITIONING) - - Fig. 5
Check that tension (A) at the centre of the belt run,
as shown in the figure, is 10--11 mm (0.39--0.43 in)
with
an
applied
(8--10 kg or 17.7--22.1 lbs).
To adjust, slacken screw (1) and reset the tension to
the values indicated above.
NOTE: If the belt is cracked or frequent adjustment
is necessary, it needs to be replaced.
OPERATION 4
COMPRESSOR BELT - - Fig. 6
Check that tension (A) of the belt shown in the figure, is
12--13 mm (0.47--0.51 in) with a load of 78--98 N
(8--10 kg or 17.7--22.1 Ibs), measured in the centre of
the belt run, as illustrated in the figure.
To adjust, slacken screw(1) and adjust belt tensioner (2).
NOTE: If the belt is cracked or frequent adjustment
is necessary, it needs to be replaced.
4--8
SECTION 4 - - LUBRICATION AND MAINTENANCE
load
of
78--98
A
N
TRE0830A
1
2
1
4
5
2
6
Advertisement
Table of Contents
