When using the narrowest tracks, the tyres may
touch the tractor with the wheels on full lock and
when the front axle is at maximum pivot position -- for
example, in deep ploughing when enter and exit the
furrows.
To avoid this problem, the axle has a steering stop
screw and a spacer which can be adjusted so as to
obtain the optimum steering angle for each wheel
track.
Turning angle can be adjusted between 40° -- 45°
and 50° by remowing screw (1) and spacer (2)
fig. 51, on the front axle of all models.
According to tire size and track width, adjustment
possibilities are shown at table below:
Tyre Size
11.2R--28
11 2R 28
12.4R--24
12 4R 24
13.6R--24
13 6R 24
360/70R--24
* Position A: Both screw and spacer installed.
* Position B: Only screw installed, without spacer.
* Position C: Both screw and spacer removed.
SECTION 3 - - FIELD OPERATIONS
STEERING ANGLE ADJUSTMENT
Track Width (mm)
1560
1671
1562
1674
1674
1760
1624
2
TRE0827A
Steering Angle (° ° ° ° )
40
50
40
50
45
50
50
1
51
Positions*
A
C
A
C
B
C
C
3--37