Table of Contents
Advertisement
1
FC-Series T Camera Installation
1.5.1
When selecting a mounting location for the FC-Series T camera, consider cable lengths and cable
routing. Ensure the cables are long enough, given the proposed mounting locations and cable routing
requirements, and route the cables before you install the components.
Use cables that have sufficient dimensions to ensure safety (for power cables) and adequate signal
strength (for video and communications). Allow space behind the camera so each cable does not
exceed its recommended minimum bend radius.
1.5.2
The camera includes a sunshield which should be used for any installation where the camera is
exposed to direct sunlight or precipitation, If the camera is mounted with the top mounting holes, the
sunshield is not used. Depending on the needs of the installation, the sunshield can be positioned in
the neutral (middle) position, or slightly forward or rearward.To change the position of the sunshield,
temporarily loosen the three 3mm hex screws on top, slide the sunshield forward or backward, and
retighten the screws.
427-0070-11-12, version 100
Prior to Cutting/Drilling Holes
Sunshield
April 2012
1-3
Advertisement
Table of Contents
