Listening To Radio Broadcasts; Selecting The Band; Auto Tuning; Manual Tuning - Sherwood R-977 Operating Instructions Manual

Listening to Radio Broadcasts

Selecting the band

1
Press the BAND button on the front panel or
TUNER button on the remote control to select the
desired band.
• Each time the button is pressed, the band
changes as follows:
FM STEREO  FM MONO  AM
("ST" light up) ("ST" goes off)
Note
• When FM stereo broadcasts are poor, due to a weak
broadcast signal, select the FM mono mode to reduce
the noise. The FM broadcasts are reproduced in
monaural sound.
DISPLAY DIMMER
PURE MONITOR
AUDIO SELECT AUDIO SUBTITLE
SURROUND STEREO
TUNER BD/BDR DVD/DVR STB/CBL
1 2 3 4
GAME AUX CD PHONO
5 6 7 8
F AUX FRBT NET/USB TV
9 0 10
REPEAT SHUFFLE FAVORITE DELETE

Auto tuning

1
Press the BAND button on the front panel or
TUNER button on the remote control to select the
desired band.
2
Press the TUNING UP(+)/DOWN(−) buttons for
more than 0.5 second.
• The tuner will now search until a station of
sufficient strength has been found. The display
shows the tuned frequency and "TUNED".
• If the station found is not the desired one,
simply repeat this operation.
•
Weak stations are skipped during auto tuning.

Manual tuning

1
Select the desired band by pressing the BAND
button on the front panel or the TUNER button on
the remote control.
2
Press the TUNING UP(+)/DOWN(−) buttons
repeatedly until the desired frequency has been
reached.
Operations
R M TE ELE T
M1 M2 M3
VOLUME ROOM2
INPUT
CH MUTE
CH.LEVEL VOLUME
CH T/V
TUNE TUNE
PRESET PRESET
TEST SETUP
M1 M2 M3
VOLUME ROOM2
INPUT
CH MUTE
CH.LEVEL VOLUME
CH T/V
TUNE TUNE
PRESET PRESET
TEST SETUP
35