Programming A Macro Function; Operating A Macro Function - Sherwood R-977 Operating Instructions Manual

Programming a macro function

The macro function enables you to program a series
of button operations (up to 10) on this remote control
into a single button. You can store up to three
separate macro command sequences into the M1,
M2, and M3 buttons.
1
Press and hold the ENTER button and one of
three NUMERIC buttons (1 ~ 3) simultaneously
corresponding to the M1 ~ M3 buttons for more
than 1 second.
•
If the macro mode is entered, the LED will
flicker once.
Example: when programming a series of
button operations into M1 button
TEST SETUP
DISC MENU HOME MENU
ENTER
DISPLAY RETURN
DISPLAY DIMMER
PURE MONITOR
AUDIO SELECT AUDIO SUBTITLE
2
Press the operation buttons you want to program
in order.
Example: when playing a BD on the
BD player connected to HDMI IN 1
connector of this receiver
1) Press the AVR button to control this receiver.
2) Press the POWER ON button to turn this
receiver on.
3) Press the AVR button to control this receiver.
4) Press the (INPUT SELECTOR) BD button to
select the desired input source.
5) Press the (DEVICE) BD button to control the
BD player.
6) Press the POWER ON button to turn the BD
player on.
7) Press the (DEVICE) BD button to control the
BD player.
8) Press  button to start playback.
POWER ON
AVR
BD
Note
• You should press the corresponding DEVICE buttons
before pressing each operation button.
SURROUND STEREO
TUNER BD/BDR DVD/DVR STB/CBL
1 2 3 4
GAME AUX CD PHONO
5 6 7 8
F AUX FRBT NET/USB TV
9 0 10
REPEAT SHUFFLE FAVORITE DELETE
BD
AVR 2
POWER ON
BD
3
Press the ENTER button.
• If the programming is performed successfully,
the LED will flicker twice.
TEST
DISC MENU
DISPLAY
DISPLAY
PURE MONITOR
AUDIO SELECT
SURROUND
To remove a macro program
 When removing a macro program, perform the
above steps 1 and 3, but skip step 2.
To change a macro program
 When a new macro program is stored into a
MACRO button with performing the above steps 1
to 3, the previous macro program is cleared from
the memory of the MACRO button.

Operating a macro function

1
Aim the remote control at the remote control
sensors of the components to be controlled and
press the MACRO button you want.
POWER ON STANDBY
REMOTE SELECT
AVR TV BD SAT
MACRO SLEEP
M1 M2 M3
VOLUME ROOM2
INPUT
CH MUTE
Note
• The codes programmed into a MACRO button will
be transmitted at an interval of 0.5 second. However,
some components may not be able to complete one
operation in 0.5 second and may miss the next code.
In this case, the macro function cannot control the
corresponding components correctly.
• Be sure to use the remote control within the remote
control operation range of the components.
• Depending on the operation status of the components,
etc., the macro function may not control the
corresponding components correctly.
Appendix
SETUP
HOME MENU
ENTER
RETURN
DIMMER
AUDIO SUBTITLE
STEREO
Example: when
operating M1 program
M1
75