Configuring Interfaces; Parallel Interface Mode - Kyocera FS-6700 User Manual

2.4. Configuring Interfaces

2.4. Configuring Interfaces

Parallel Interface Mode

2-24
The printer is equipped with both a parallel and serial interface. Independent settings can be
made for each interface. Optional interfaces can also be installed.
To configure each interface, press the MODE key and use the + or – key to select the interface you
wish to make settings for.
Note
This interface selection does not select which interface data will be received from. The printer
automatically selects that interface.
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally,
this interface is used under the default setting Nibble (high).
Parallel Interface Mode
Display Description
High speed data communication is used in compliance with the IEEE
Nibble (high)
1284 standard.
The printer automatically changes its communication mode.
Auto
The parallel interface is configured according to standard specifications.
Normal
The parallel interface is in high-speed mode.
High speed
After setting the interface, be sure to reset the printer or turn the power off at least once. The new
setting will be enabled thereafter.