Kyocera FS-6700 User Manual page 162

Message
>Read fonts
Failed
I/F occupied
Corrective Action
09: The capacity of the memory card is insufficient. This error
code appears when an attempt is made to write more data on the
memory card than available memory. To halt the writing of data,
first stop data transmissions from the computer, and then the
printer's CONTINUE key. Press the FORM FEED key if the
message Waiting will appear in the message display. The
message display will return to reading Ready.
11: The memory card is full of data items. The number of data
items which can be written on the memory card is limited to 127.
Pressing the CONTINUE key will restore the message Ready in
the message display.
13: This is a logical error. Try substituting another flash memory
card.
17: The flash memory card cannot be written due to insufficient
printer memory. Either delete unnecessary macros and/or fonts
stored in the printer, or expand the printer's available memory.
18: This is a write error. Try substituting another flash memory
card. (Error codes 13 through 18 apply only to flash memory
cards.)
The amount of memory available for the fonts header parts of
font is too small to load more fonts. Try deleting unnecessary
fonts and macros.
This message is displayed when you attempt to use the printer's
control panel to change the environmental settings on the
interface from which data are presently being received.
Chapter 5 Troubleshooting
5-17