Basic Requirements - Kyocera FS-6700 User Manual

1.1. Positioning the Printer

Basic requirements

1-4
The printer will work best if it is installed in a location that is:
Near the computer
If the parallel interface is used to connect the printer to the computer, the connecting cable should
be shielded type and not be longer than 3 meters (10 feet).
Level and well supported
Place the printer on a sturdy table or desk. Do not place the printer on an unstable cart, stand, or
table. The printer may fall, causing injury, or serious damage to the printer.
Near an AC wall outlet, preferably one that can be used for the printer alone (see section Power
Supply on next page).
Power requirements are:
120 V (U.S.A./Canada), 220 V to 240 V (European countries), 10 % at
Voltage
each voltage
60 Hz (120 V/220 V to 240 V), 2 %
Frequency
50 Hz (220 V to 240 V), 2 %
Current capacity Max. 8 A at 120 V, or Max. 4 A at 220 V to 240 V
The outlet should be earthed, or an adapter should be used.
If an extension cord is used, the total length of the power cord plus extension should be 5 meters
(17 feet) or less.
Well ventilated, not too hot or cold, and not too damp or dry
Temperature 10˚C to 32.5˚C (50˚F to 90.5˚F)
Humidity 20% to 80%
If you install the printer where the temperature or humidity is outside the above ranges, you may
not get the best print quality, and there will be an increased chance of paper jams.