Testing The Expansion Memory - Kyocera FS-6700 User Manual

1.7. Memory Expansion Installation

Testing the Expansion Memory

1-44
Removing SIMMs
To remove a SIMM, carefully pull the end catches slightly outwards and tilt the SIMM as shown,
then pull the SIMM out of the socket.
Reverse the procedure under Withdrawing the Main Circuit Board from the Printer to put the main
circuit board back into the printer.
After you have finished installing SIMMs in the printer, test the printer to see if the installation has
been successful.
To test the expansion memory, proceed as follows:
1. Make sure the power switch is off. Plug the power cord into the printer and turn power on.
2. When the printer is on-line, press the STATUS key.
3. If the installation has been successful, the Total memory (Memory Allocation) of the status page
will show the expanded memory size corresponding to the amount of memory added. (The
factory installed memory size is 4 MB.)