Colored Paper; Recycled Paper - Kyocera FS C8026N Operation Manual

Envelopes
Envelopes must be fed manually.
Since the composition of an envelope is more complex than
that of ordinary paper, it is not always possible to ensure
consistent printing quality over the entire envelope surface.
Normally, envelopes have a diagonal grain direction. See
section Grain on page 2-5. This direction can easily cause
wrinkles and creases when envelopes pass through the
printer. Before purchasing envelopes, make a test print to
check whether the printer accepts the envelope.
Other handling cautions follow:
• Do not use envelopes that have an encapsulated liquid
adhesive.
• Avoid a long printing session for envelopes only.
Extended envelope printing can cause premature printer
wear.
• To avoid jams caused by curled envelopes, stack the
printed envelopes no higher than 10 on the output tray.

Colored paper

Colored paper should have the same specifications as the
white bond paper listed. In addition, the pigments in the
paper must be able to withstand the heat of fusing during the
printing process (up to 200
Pre-printed paper
Pre-printed paper should basically be bond paper. The inks
on the paper must be able to withstand the heat of fusing
during the printing process and must not be adversely
affected by silicon oil. Do not use paper with any kind of
coating, such as calendar stock.

Recycled paper

Select recycled paper that has the same specifications as
white bond paper. See Table 2-1 on page
paper, however, does not have to be as white as white bond
paper.
Before purchasing recycled paper, make a test
using the printer and check whether the print
quality is satisfactory.
Note
° °
C or 392 F).
2-2. Recycled
2-11
2.4 Special Paper