Troubleshooting - Kyocera FS-1118MFP Advanced Operation Manual

Using COMMAND CENTER
Symptom
I can't access
COMMAND
CENTER.
Characters do not
display properly in
COMMAND
CENTER.
I can't access the
other pages.
I can't perform
settings.
8-28

Troubleshooting

Consult the table below to find basic solutions for problems you may encounter with
COMMAND CENTER.
Check Items
Is the power turned on to this
machine?
Is the network cable properly
connected?
Are the network settings that
are made in this machine
correct?
Is the IP address for this
machine entered correctly?
Are the LAN settings that are
made in your browser
application correct?
Has the administrator set up
an IP Filter function?
The SNMP Read Community
settings function as passwords
to control read and write
access to the machine via
SNMP.
Does the version of your
browser application support
operation using COMMAND
CENTER?
Does the version of your
browser application support
operation using COMMAND
CENTER?
Has the administrator set a
password?
Is the printer or scanner
currently in operation?
Corrective Action
Turn the power on to this
machine, wait until it is a ready
state, and try to access
COMMAND CENTER.
Connect the network cable
properly.
Perform the network settings
from the operation panel.
Contact your network
administrator for the appropriate
settings.
Enter the correct IP address.
Check the IP address with your
network administrator.
Check the settings made in your
browser application. Refer to the
Help function in your browser.
Access COMMAND CENTER
from an approved IP address.
Access COMMAND CENTER
from an approved Read
Community.
Use a browser application that
supports COMMAND CENTER.
Use a browser application that
supports COMMAND CENTER.
Enter the password.
Wait until the operation has
been completed.
ADVANCED OPERATION GUIDE
Reference
Operation
Guide
Operation
Guide
page 3-2
page 3-4
-
page 8-19
page 8-22
page 8-1
page 8-1
page 8-6
-