Systemunit Irsensor - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents

SystemUnit IrSensor

The codec has a short-range IR sensor underneath the power button. It may be used with the
remote control, but it is not intended for regular operation. It should be used only when required
for troubleshooting or system recovery. In regular operation, the IR sensor on the camera
should be used with the remote control, refer to the Cameras Camera [1] setting.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: The IR sensor of the codec is disabled whenever the IR sensor of the camera is
enabled. The IR sensor of the codec is enabled only if the IR sensor of the camera is
disabled.
Off: Disable the IR sensor of the codec.
On: Enable the IR sensor of the codec.
SystemUnit IrSensor: Auto
Example:
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
103
Administrator Guide
Setting passwords Appendices