Factory Resetting The Touch 10 User Interface - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents
Factory resetting the Touch 10
user interface
In an error situation it may be required to factory reset
the Touch 10 user interface to recover connectivity. This
should be done only when in contact with the Cisco support
organization.
When factory resetting Touch 10 the pairing information is
lost, and the Touch itself (not the video system) is reverted to
factory defaults.
Touch 10 restarts after the reset and must be paired to the
video system anew. When successfully paired it receives a
new configuration from the video system.
It is not possible to undo a factory reset.
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface
Factory resetting Touch 10
1. Locate the
2. Press and hold the
and green). It takes approximately 10 seconds.
3. Press the
Touch 10 automatically reverts to the default factory
settings and restarts.
System settings
Mute and Volume down buttons.
Volume down
Mute button until it starts blinking (red
Volume down button twice.
140
Setting passwords
Mute
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices Appendices