Conference [1..1] Micunmuteondisconnect Mode; Conference [1..1] Farendcontrol Mode; Conference [1..1] Donotdisturb Mode; Conference [1..1] Farendcontrol Signalcapability - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents

Conference [1..1] MicUnmuteOnDisconnect Mode

Determine if the microphones shall be unmuted automatically when all calls are disconnected.
In a meeting room or other shared resources this may be done to prepare the system for the
next user.
Requires user role: ADMIN
Value space: <Off/On>
Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.
Conference 1 MicUnmuteOnDisconnect Mode: On
Example:

Conference [1..1] DoNotDisturb Mode

Determine whether to allow incoming calls.
Requires user role: USER
Value space: <Off/On/Timed>
Off: The incoming calls will come through as normal.
On: All incoming calls will be rejected and they will be registered as missed calls. The calling
side will receive a busy signal. A message telling that Do Not Disturb is switched on will
display on the Touch controller or main display. NOTE: This setting is not recommended as
all calls will be rejected until the setting is manually turned off. The recommended option is
Timed.
Timed: When set to timed (default), the system will revert back and allow incoming calls after
the specified timeout, defined by the setting: Conference DoNotDisturb DefaultTimeout.
Conference 1 DoNotDisturb Mode: Timed
Example:

Conference [1..1] DoNotDisturb DefaultTimeout

This setting determines the default duration of a Do Not Disturb session, i.e. the period when
incoming calls are rejected and registered as missed calls. The session can be terminated
earlier by using the user interface (remote control or Touch controller) or the Conference
DoNotDisturb Mode setting. The default value is 60 minutes.
Requires user role: ADMIN
Value space: <0..1440>
Range: Select the number of minutes (between 0 and 1440, i.e. 24 hours) before the Do Not
Disturb session times out automatically.
Conference 1 DoNotDisturb DefaultTimeOut: 60
Example:
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings

Conference [1..1] FarEndControl Mode

Lets you decide if the remote side (far end) should be allowed to select your video sources and
control your local camera (pan, tilt, zoom).
Requires user role: ADMIN
Value space: <Off/On>
Off: The far end is not allowed to select your video sources or to control your local camera
(pan, tilt, zoom).
On: Allows the far end to be able to select your video sources and control your local camera
(pan, tilt, zoom). You will still be able to control your camera and select your video sources
as normal.
Conference 1 FarEndControl Mode: On
Example:

Conference [1..1] FarEndControl SignalCapability

Set the far end control (H.224) signal capability mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the far end control signal capability.
On: Enable the far end control signal capability.
Conference 1 FarEndControl SignalCapability: On
Example:
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
67
Administrator Guide
Setting passwords Appendices