Video Settings; Video Allowwebsnapshots; Video Camctrlpip Callsetup Duration; Video Defaultpresentationsource - Cisco TelePresence SX20 Administrator's Manual

Cisco TelePresence SX20 Quick Set
Contents

Video settings

Video AllowWebSnapshots

Note: This setting is only available in TC7.3.0 to TC7.3.2.
Allow or disallow snapshots being taken of the local input sources, remote sites and
presentation channel. If snapshots are allowed, the snapshots may be captured both when idle
and in a call.
When snapshots are taken from a remote device, e.g. the web interface, a notification appears
on the video system's screens to alert the users that remote monitoring is in operation.
Requires user role: ADMIN
Value space: <Off/On/LocalDeviceOnly>
Off: It is not possible to capture snapshots.
On: Snapshots can be captured and displayed anywhere, e.g. on the web interface.
LocalDeviceOnly: Snapshots can only be captured and displayed on devices running the
experimental Cisco Proximity feature. The devices must be in the same room as the video
system. It will not be possible to take and see snapshots on the web interface or by using
3rd party integrations.
Video AllowWebSnapshots: LocalDeviceOnly
Example:

Video CamCtrlPip CallSetup Mode

This setting is used to switch on self-view for a short while when setting up a call. The Video
CamCtrlPip CallSetup Duration setting determines for how long it remains on. This applies when
self-view in general is switched off.
Requires user role: ADMIN
Value space: <Off/On>
Off: self-view is not shown automatically during call setup.
On: self-view is shown automatically during call setup.
Video CamCtrlPip CallSetup Mode: On
Example:
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings

Video CamCtrlPip CallSetup Duration

This setting only has an effect when the Video CamCtrlPip CallSetup Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is shown
before it is automatically switched off.
Requires user role: ADMIN
Value space: <1..60>
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
Video CamCtrlPip CallSetup Duration: 10
Example:

Video DefaultPresentationSource

Define which video input source shall be used as the default presentation source when you
press the Presentation key on the remote control. If using the Touch controller this setting has
no effect. The Video Input Source n Connector setting defines which input connector to use for
input source n.
Requires user role: USER
Value space: <1/2>
Range: Select the video source to be used as the presentation source.
Video DefaultPresentationSource: 2
Example:
www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
108
Administrator Guide
Setting passwords Appendices