Gehl SL7600 Operator's Manual page 9

Mandatory Safety Shutdown Procedure
Before cleaning, adjusting, lubricating, servicing the unit or leaving it
unattended:
1. Move the drive control handle(s) to the neutral position.
2. Lower the lift arm and attachment completely. If the lift arm must be left
in the raised position,
device (page 17).
3. Move the throttle to the low idle position, shut off the engine and remove
the key.
4. Before exiting, move the lift/tilt control(s) to verify that the controls do
not cause movement of the lift arm and hitch.
Safety Reminders
Before Starting
Ü Do not modify the ROPS/FOPS unless instructed to do so in installation
instructions. Modifications such as welding, drilling or cutting can weaken
the structure and reduce the protection it provides. A damaged
ROPS/FOPS cannot be repaired — it must be replaced.
Ü To ensure safe operation, replace damaged or worn-out parts with genuine
Gehl service parts.
Ü Gehl skid steer loaders are designed and intended to be used only with Gehl
attachments or approved referral attachments. Gehl cannot be responsible
for operator safety if the loader is used with a non-approved attachment.
Ü Remove all trash and debris from the machine each day, especially in the
engine compartment, to minimize the risk of fire.
Ü Always face the loader and use the hand holds and steps when getting on
and off the loader. Do not jump off the loader.
Ü Never use starting fluid (ether).
Ü Walk around the machine and warn all nearby personnel before starting the
machine.
Ü Always perform a daily inspection of the machine before using it. Look for
damage, loose or missing parts, leaks, etc.
During Operation
Ü Machine stability is affected by: the load being carried, the height of the
load, machine speed, abrupt control movements and driving over uneven
terrain.
DISREGARDING ANY OF THESE FACTORS CAN CAUSE THE
LOADER TO TIP, THROWING THE OPERATOR OUT OF THE SEAT OR
LOADER, RESULTING IN DEATH OR SERIOUS INJURY.
operate with the seatbelt fastened and the restraint bar lowered.
ALWAYS
Do not exceed the machine's Rated Operating Load. Carry the load low.
Move the controls smoothly and gradually, and operate at speeds
appropriate for the conditions.
908274/BP1202
to properly engage the lift arm support
BE SURE
Therefore,
6