Gehl SL7600 Operator's Manual page 29

Lift/Tilt Control
Moving the lift arm and tilting the attachment are accomplished by
movement of the right T-Bar. To raise the lift arm, pull the control straight
rearward; to lower the lift arm, push the control straight forward. To tilt the
attachment downward, twist the control clockwise; to tilt the attachment
up or back, twist the control counterclockwise.
Note: The speed of the lift/tilt motion is directly proportional to the amount of
T-Bar movement and engine RPM.
To place the lift arm in the detent (float) position, push the right T-Bar all the
way forward, into the detent. This position allows the lowered lift arm to float
while traveling over changing ground conditions.
WARNING
Never push the lift/tilt T-Bar control into the float
position with the attachment loaded or raised, because this will
cause the lift arm to lower rapidly.
908274/BP1202 26