Gehl SL7600 Operator's Manual page 41

Power hitch: Activate the switch to lock the hitch and fully engage the
latch pins.
Important: To check that the attachment is properly installed, apply
downward pressure to the attachment prior to operating.
Connect Auxiliary Hydraulic Couplings
Note: With the engine
OFF
auxiliary hydraulic control can be moved to relieve any pressure in the hydraulic
system.
Standard Auxiliary Hydraulics
Coupler hookup is located on the left lift arm. The top coupler is pressure,
the bottom coupler is return when the auxiliary control is in the detent
position.
High Flow Auxiliary Hydraulics
Coupler hookup is located on the right lift arm. The top coupler is
pressure, the middle coupler is return when the auxiliary control is in the
detent position. The bottom coupler is the dedicated case drain.
Remove Attachment
1. Tilt the hitch back until the attachment is off the ground.
2. Exercise the
MANDATORY SAFETY SHUTDOWN PROCEDURE
3. Relieve any hydraulic pressure in the auxiliary and attachment lines.
a. Turn the key
ON
b. With the restraint bar down, move the auxiliary hydraulic control
back and forth. This will relieve the pressure in the hydraulic system.
4. With the engine
OFF
the auxiliary hydraulic hoses.
5. Manual hitch: Rotate the hitch's latch lever to the right to fully retract the
latch pins.
Power hitch: Turn the key
switch to unlock the hitch and fully retract the latch pins.
6. Start the engine and be sure that the lift arm is fully lowered and in contact
with the loader frame.
7. Tilt the hitch forward and slowly back the loader until the attachment is
free from the loader.
Self-Leveling
The feature is designed to keep the attachment level while the lift arm is being
raised.
908274/BP1202
, key in the position and the restraint bar down, the
ON
(do not start the engine).
, leave the operator's compartment and disconnect
(do not start the engine) and activate the
ON
(page 6).
38