Gehl SL7600 Operator's Manual page 44

Scraping with a Bucket
For scraping, the loader should be operated in the
forward direction. Position the lift arm down
against the loader frame. Tilt the bucket cutting
edge forward at a slight angle to the surface being
scraped. While traveling slowly forward with the
bucket in this position, material can flow over the
cutting edge and collect inside the bucket.
Leveling the Ground
Drive the loader to the far edge of the area to be
leveled. Tilt the bucket forward to place the bucket
cutting edge at a 30 to 45 degree angle to the
surface being leveled. Then place the lift arm into
the float position and drive the loader rearward,
dragging the dirt and, at the same time, leveling it.
Note: The float (detent) position for T-bar and dual
hand controlled loaders is reached by pushing the
right handle all the way forward. For hand/foot
controlled loaders, use your toes to push the front of
the left pedal all the way down.
WARNING
obstacles. Always look in the direction of travel.
41
Check that the work area is clear of people and
Fig. 26: Scraping
Fig. 27: Leveling the
Ground
908274/BP1202