Install The Front Plate; Install The Safety Barrier Screen; Pilot And Burner Information - Vermont Castings SDDVTCSBDSB Installation And Operating Instructions Manual

Install the Front Plate

Hold the front plate by the window bars and lift it into posi-
tion, engaging the two steel tabs on the top corners behind
the adjacent bosses in the side plates. (Figure 53) Then
seat the Front against the sides so the tabs at the bottom
lip engage with the notches in the stove legs.
When properly installed, the bottom of the Front Plate can-
not be pulled away from the sides without also lifting it.
S
AFETY
NOTE: A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this
appliance and shall be installed for the protection of
children and other at risk individuals. If the barrier
becomes damaged, the barrier shall be replaced with
the manufacturer's barrier for this appliance.* Any
safety screen, guard, or barrier removed for servicing
the appliance must be replaced prior to operating the
appliance.
* See parts list for model number.
The safety barrier has been designed to work with the
doors open or closed.
1. Remove screen from packaging.
2. Place the two bottom hooks over the bottom edge of
the stove opening Figure 54
3. Press the screen against the stove snapping the two
spring fingers until the screen fits securely in place.
NOTICE: It is the responsibility of the installer to ensure
the barrier is affixed to the stove at the time of installa-
tion.
WARNING: The safety screen barrier
must be installed after the glass front is
in place. It is NOT a replacement for the
glass and the unit must NOT be oper-
ated without the glass in place.
20306760
Install the Safety Barrier
CERTIFIED
B
ARRIER
Stardance® Direct Vent/Natural Vent Gas Heater
Engage steel tabs
gehind the cast
iron bosses
Control Door
Bottom tabs engage
notch in the leg.
Figure 53 Install the front plate.
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
DANGER
Une barrière visant à réduire le risque de brûlure
Bottom
par le hublot chaude est fournie avec cet
Hooks
appareil et doit être installé.
Figure 54 Install safety barrier screen.
Stardance
Install Screen
12/14
ST474
ST474
Stardance
Front
10/3/00
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
29